Flange: PNG image to DXF
A real Nest Ready conversion of an example drawing made for the purpose. Below are the drawing as uploaded, the DXF Nest Ready produced and the facts of that run, including anything the reviewer had to do.
No card required. Bring your own drawings.
The drawing, and the DXF that came out
What is worth noticing in this example?
A PNG is a picture of the drawing, like a scan: there are no lines in the file.
The six holes are dimensioned once, as 6 × Ø18 equally spaced on a Ø190 pitch circle. In the DXF each hole is a circle of its own, at its own position; the pitch circle is a construction line, so it is left out.
The part was flagged because it came from an image, then checked in review and accepted with no corrections.
What happened in this run?
- Time to ready
- about 15 s from submission to ready
- Features
- outer profile, 1 bore, 6 holes
- Flags
- This came from a scan or photo
- Review
- Checked and accepted in review, with no corrections
The time is from submission to ready, so it includes any wait in the queue. It is this run’s figure, not a promise.
What was kept, and what was left behind?
Kept in the DXF
- Ø250 outer profile
- Ø110 bore
- 6 × Ø18 holes on the Ø190 pitch circle
Left behind
- Dimensions, leaders and arrowheads
- Centre lines and the pitch circle
- General notes
- Title block and revision table
- Border and zone markings
Check every DXF against the drawing before cutting.
Download the DXF
The file exactly as it was downloaded from Nest Ready.
Convert your next engineering drawing to DXF.
Upload a PDF, scanned drawing or drawing image and see the part geometry Nest Ready can extract.